asbestos REMOVAL
SimplyReno Inc offers the following asbestos removal services:
Paper Duct Wrap
Plaster
Drywall
Drywall Joint Compound
Ceiling Stipple
Vinyl Floor Tiles
Ceiling Tiles
Parging
Stucco
When removing ACM paper duct wrap the following steps should be followed:
Proper Personal Protective Equipment for the workers removing asbestos, including the proper face mask
Amended water is applied to the ACM in order to reduce the amount of airborne fibers during the removal
Carefully loosen the register boot
Remove the paper duct wrap using a hepa vacuum
The ACM will be double bagged and then be properly disposed of following the Ontario Regulation 278/05
When removing other forms of ACM the following steps should be followed
Proper Personal Protective Equipment for the workers removing asbestos, including the proper face mask
The area should be contained prior to disturbing the ACM
Hepa scrubbers should be installed within the contained area to clean the air of any airborne fibers
Amended water is applied to the ACM in order to reduce the amount of airborne fibers during the removal
Carefully remove the ACM
The containment will be thoroughly hepa vacuum after the removal the clean up any remaining dust and fibers left on the surface
The ACM will be double bagged and then be properly disposed of following the Ontario Regulation 278/05
mold remediation
SimplyReno Inc offers the following mold removal services:
Bathroom mold
Basement mold
Kitchen mold
Attic mold
Moldy drywall, plaster
Moldy ceilings
Moldy baseboards
Moldy structure such as studs, framing, sheathing
Many of the same steps are involved when removing unwanted mold from your indoor environment, as when you are removing asbestos.
Proper Personal Protective Equipment for the workers removing asbestos, including the proper face mask
The area should be contained prior to disturbing the mouldy materials
Hepa scrubbers should be installed within the contained area to clean the air of any airborne mould spores
Carefully remove the mouldy materials until you have removed approximately 2 feet of clean material in each direction
Clean any visible mould from framing, concrete walls and/ or floors
Apply an anti-microbial agent to the cleaned area
The containment will be thoroughly hepa vacuum after the removal the clean up any remaining dust and spores left on the surface
Find and repair the water source before rebuilding the area